Egger cantilever pumps

Egger cantilever pumps

Egger cantilever pumps are designed to pump wastewater and other challenging media from the bottom of a tank, well or reservoir without clogging.

The unique design

The pumps have no shaft seals or bearings that are exposed to the process fluid, allowing for unlimited dry running and easy maintenance. This design is available for the Egger Turo Vortex, TEO and EO / EOS process pumps.

Advantages and properties

  • Available in various materials: Hardened cast iron (55-60 HRC), 1.4593, 1.4588 and more
  • Temperatures above 100 ° C are no problem
  • Free passage equal to the pressure of the pump (up to 150mm)
  • Clog-free (also with gloves, rope, etc.)
  • No shaft seal in the pit
  • No bearings in the pit, only bearings for the motor
  • Unlimited dry running possible, so no damage to the pump if the level measurement is defective
  • The pit can be completely emptied when a suction pipe is installed, up to 8 cm from the bottom.
  • Available for Atex Zone 1 and 2 (Zone 0 also possible with shaft seal)

Applications

Egger cantilever pumps are used in various industries, including:

  • Chemical and petrochemical industry
  • Wastewater treatment
  • Car industry
  • Steel industry
  • Environmental technology
  • Paper and fiber processing industries
View the brochure about the design and benefits of the Egger cantilever pumps:

Contact us

+31 (0)546 45 80 72

Available between 08:15 and 17:00

Available 24/7 for calamities

Address Twentepoort Oost 25, 7609RG Almelo

E-mail Info@inventflow.nl

en_USEN
Scroll to Top